Terms
F
FHA strap-
Metal straps that are used to repair a bearing wall "cut-out",
and to "tie together" wall corners, splices, and bearing
headers. Also, they are used to hang stairs and landings to bearing
headers.
Face nail- To install
nails into the vertical face of a bearing header or beam.
Faced concrete- To
finish the front and all vertical sides of a concrete porch, step(s), or
patio. Normally the "face" is broom finished.
Facing brick- The
brick used and exposed on the outside of a wall. Usually these have a
finished texture.
Fascia- Horizontal
boards attached to rafter/truss ends at the eaves and along gables. Roof
drain gutters are attached to the fascia.
Felt- Tar paper.
Installed under the roof shingles. Normally 15 lb. or 30 lb.
Female- Any part,
such as a nut or fitting, into which another (male) part can be
inserted. Internal threads are female.
Ferrule- Metal tubes
used to keep roof gutters "open". Long nails (ferrule spikes)
are driven through these tubes and hold the gutters in place along the
fascia of the home.
Field measure- To
take measurements (cabinets, countertops, stairs, shower doors, etc.) in
the home itself instead of using the blueprints.
Finger joint- A
manufacturing process of interlocking two shorter pieces of wood end to
end to create a longer piece of dimensional lumber or molding. Often
used in jambs and casings and are normally painted (instead of stained).
Fire block- Short
horizontal members sometimes nailed between studs, usually about halfway
up a wall. See also 'Fire stop'.
Fire brick- Brick
made of refractory ceramic material which will resist high temperatures.
Used in a fireplace and boiler.
Fireplace chase flashing
pan- A large sheet of metal that is installed around and
perpendicular to the fireplace flue pipe. It's purpose is to confine and
limit the spread of fire and smoke to a small area.
Fire-resistive or Fire
rated- Applies to materials that are not combustible in the
temperatures of ordinary fires and will withstand such fires for at
least 1 hour. Drywall used in the garage and party walls are to be fire
rated, 5/8", Type X.
Fire retardant chemical-
A chemical or preparation of chemicals used to reduce the flammability
of a material or to retard the spread of flame.
Fire stop- A solid,
tight closure of a concealed space, placed to prevent the spread of fire
and smoke through such a space. In a frame wall, this will usually
consist of 2 by 4 cross blocking between studs. Work performed to slow
the spread of fire and smoke in the walls and ceiling (behind the
drywall). Includes stuffing wire holes in the top and bottom plates with
insulation, and installing blocks of wood between the wall studs at the
drop soffit line. This is integral to passing a Rough Frame inspection.
See also 'Fire block'.
Fishplate (gusset)- A
wood or plywood piece used to fasten the ends of two members together at
a butt joint with nails or bolts. Sometimes used at the junction of
opposite rafters near the ridge line. Sometimes called a gang nail
plate.
Fish tape- A long
strip of spring steel used for fishing cables and for pulling wires
through conduit.
Fixed price contract-
A contract with a set price for the work. See Time and Materials
Contract.
Fixed rate- A loan
where the initial payments are based on a certain interest rate for a
stated period . The rate payable will not change during this
period regardless of changes in the lender's standard variable rate.
Fixed Rate Mortgage-
A mortgage with an interest rate that remains the same over the years.
Flagstone (flagging or
flags)- Flat stones (1 to 4 inches thick) used for walks, steps,
floors, and vertical veneer (in lieu of brick).
Flakeboard- A
manufactured wood panel made out of 1"- 2" wood chips and
glue. Often used as a substitute for plywood in the exterior wall and
roof sheathing. Also called OSB or wafer board.
Flame retention burner-
An oil burner, designed to hold the flame near the nozzle surface.
Generally the most efficient type for residential use.
Flashing- Sheet metal
or other material used in roof and wall construction to protect a
building from water seepage.
Flat mold- Thin wood
strips installed over the butt seam of cabinet skins.
Flat paint- An
interior paint that contains a high proportion of pigment and dries to a
flat or lusterless finish.
Flatwork- Common word
for concrete floors, driveways, basements, and sidewalks.
Floating- The
next-to-last stage in concrete work, when you smooth off the job and
bring water to the surface by using a hand float or bull float.
Floating wall- A
non-bearing wall built on a concrete floor. It is constructed so that
the bottom two horizontal plates can compress or pull apart if the
concrete floor moves up or down. Normally built on basements and garage
slabs.
Fluorescent lighting-
A fluorescent lamp is a gas-filled glass tube with a phosphor coating on
the inside. Gas inside the tube is ionized by electricity which
causes the phosphor coating to glow. Normally with two pins that
extend from each end.
Flue- Large pipe
through which fumes escape from a gas water heater, furnace, or
fireplace. Normally these flue pipes are double walled, galvanized sheet
metal pipe and sometimes referred to as a "B Vent". Fireplace
flue pipes are normally triple walled. In addition, nothing combustible
shall be within one inch from the flue pipe.
Flue collar- Round
metal ring which fits around the heat flue pipe after the pipe passes
out of the roof.
Flue damper- An
automatic door located in the flue that closes it off when the burner
turns off; purpose is to reduce heat loss up the flue from the
still-warm furnace or boiler.
Flue lining- 2-foot
lengths, fire clay or terra-cotta pipe (round or square) and usually made in
all ordinary flue sizes. Used for the inner lining of chimneys
with the brick or masonry work done around the outside. Flue linings in
chimneys runs from one foot below the flue connection to the top of the
chimney.
Fly rafters- End
rafters of the gable overhang supported by roof sheathing and lookouts.
Footer, footing-
Continuous 8" or 10" thick concrete pad installed before and
supports the foundation wall or monopost.
Forced air heating -
A common form of heating with natural gas, propane, oil or electricity
as a fuel. Air is heated in the furnace and distributed through a set of
metal ducts to various areas of the house.
Form- Temporary
structure erected to contain concrete during placing and initial
hardening.
Foundation- The
supporting portion of a structure below the first floor construction, or
below grade, including the footings.
Foundation ties-
Metal wires that hold the foundation wall panels and rebar in place
during the concrete pour.
Foundation waterproofing-
High-quality below-grade moisture protection. Used for below-grade
exterior concrete and masonry wall damp-proofing to seal out moisture
and prevent corrosion. Normally looks like black tar.
Frame Inspection- The
act of inspecting the home's structural integrity and it's compliance to
local municipal codes.
Framer-The carpenter
contractor that installs the lumber and erects the frame, flooring
system, interior walls, backing, trusses, rafters, decking, installs all
beams, stairs, soffits and all work related to the wood structure of the
home. The framer builds the home according to the blueprints and must
comply with local building codes and regulations.
Framing- Lumber used
for the structural members of a building, such as studs, joists,
and rafters.
Frieze- In house
construction a horizontal member connecting the top of the siding with
the soffit of the cornice.
Frost lid- Round
metal lid that is installed on a water meter pit.
Frost line- The depth
of frost penetration in soil and/or the depth at which the earth will
freeze and swell. This depth varies in different parts of the country.
Furring strips-
Strips of wood, often 1 X 2 and used to shim out and provide a level
fastening surface for a wall or ceiling.
Fuse- A device often
found in older homes designed to prevent overloads in electrical lines.
This protects against fire. See also 'circuit breakers'.
Some information courtesy
of www.HomeBuildingManual.com